Forklift Safety Operations Management Code must see: an electric forklift driver must hold special equipment safety supervision and management department issued a valid driver's license induction operation is prohibited without a license and drink-driving. Second, the driver should be compliance law, standardized operation, safe driving, raise "safety first, prevention first" ideology. Third, while driving the truck ban in high-altitude operations personnel with fork lift, in order to avoid falling from height accidents; prohibiting the use of a single fork operation, fork load carrying capacity should be consistent with the provisions prohibit overloading operations. Fourth, forklifts Electric Stacker disabled job-speed fork to take goods, prohibited personnel standing on the forks; prohibit officers standing around when the fork fork to take cargo operations, in order to avoid collapse of the goods wounding. Five, the driver of the vehicle should be checked before the job of lifting chain, door frame, fork without injury, bolts are secure; check whether you need refueling, lubricants, check the startup, operation, and braking performance; and checking lighting, sound signal is complete and valid, and then start to confirm normal operation; after starting the engine, listen to police engine running, check order status of each instrument. Sixth, the driver started the truck should look around before, after confirming that no obstacles impede traffic safety start; start when loading a smooth start slowly and make sure smooth and reliable cargo. Seven, the driver at the time of the fork goods, demand inspection fork spacing, so that the two forks load balancing electric stacker procurement, fork truck should be as thorough load below Stacker, attention should not touch the tip of the fork other goods; With the smallest goods to stabilize mast tilting, avoid sliding backwards. The bottom of the fork height from the ground should be kept at a distance of 300-400mm travel. Forklift routine maintenance: 1, cleaning the truck dirt, mud and dirt Egypt, key positions are: fork frame and door frame slide, generator and starter, battery electrodes fork columns, tanks, air filter. 2, check all parts of fastening, focusing on: Fork supporting, lifting chain tensioning screw, wheel bolts, wheel fixed pin, brakes, steering screws. 3, check the steering of reliability, flexibility. 4. Check for leaks Stacker, focusing on: all fittings, diesel tank, sump, pump the brake, lift cylinders, tilt cylinders, tanks, pumps, engine oil pan, torque converter, transmission, drive axle The main reduction gear, hydraulic steering, steering cylinder. 5. Check the tire pressure: less than the specified value should be added to confirm that no leak. Check the tire tread and side without damage, the rim is deformed. 6, brake fluid, water check: Check the brake fluid is within the range of the scale, and check whether mixed with air in the brake lines. When you add brake fluid to prevent dust, water mixed. When water is added to the tank, clean water manual stacker car use, the use of antifreeze, should bear the same antifreeze. When the water temperature is higher than 70 ℃, do not open the radiator cap when you open the lid, a thin pad of cloth, do not wear gloves tighten radiator cap. Manual Stacker, Stacker Xuwen, a car will go by Ian Ian electric forklift electric forklift sales company in Shenzhen. Ian electric forklift sales company in Shenzhen (www.szyien.com) strong, credible, in Shenzhen, Guangdong stacking handling machinery industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Ian electric forklifts and you work into the brilliant, for a better future!